Product Review

~ For chips, cracks, pits, gouges, reattaching or rebuilding lost stone pieces, or for the ultimate counter top installation adhesive, you need II 29. When dry II 29 is an impenetrable solid shield that is an unbreakable bond. II 29 is completely non-toxic, food-safe and simple to use. For years I.I. 29 has been the #1 install and rapid-repair epoxy used by the pro's. The extended 15 minute application time allows for proper alignment and application for repairing or installing without needing to rush...then instantly dries after the application time is up. So you don't wait for projects to dry. I.I. 29 strongly bonds to most all projects all around the house... not just stone and tile. See our EZ-TINT 4 pack for tinting instructions //// REBUILDING MISSING CHIPS: After tinting, fill the epoxy into the repair area. Shape into place. Let dry. Razor off the excess and continue shaping with safety razor. //// CHIPPED STONE: No tint needed if you have a clean break where the piece can be reattached tightly. Apply epoxy to one side and push firmly into place. Always clamp for the most invisible of seams or tape tightly down with duct tape. //// CRACKS: Cracks must be wide as a credit card for the epoxy to be able to fill the crack. After tinting the epoxy, fill crack to the surface. Allow to self level for a glossy finish or once excess is dried, razor the surface level for a matted, travertine type finish. Remains flexible for hours if you decide to dig out attempt until you get exactly the finished look you desire. /////// COUNTER TOP INSTALLATION: Joint lines do not need to be taped since amazingly, the dried excess will not stick to the slick finished surfaces. Simply mix equal amounts of Resin and Hardener and apply to one or both edges. Clamp for maximum bond. Do not remove uncured excess epoxy. Let dry then simply razor off the excess in apx. 30 minutes once excess is dry-to-touch.