Product Review
The Product is Designed and Made by Seamax Marine
ADJUSTABLE DESIGN: These wheels have 4 adjustment positions for length and angle to adjust the leg length, push in the spring loaded buttons on each side of the leg and either pull or push to lengthen or shorten. To adjust the leg angle, push down on the spring loaded bar near the top of the leg assembly and move the leg assembly to the desired location. To remove the leg assembly from the bracket, pull out the quick release pin located at the top of the leg assembly. MAX LOAD: This dolly set is designed for boats with solid outboard transom, the length of the boat should be less than 16FT for easier moving. Total weight should not exceed 600 Lbs including boat, outboard and all accessories. INSTALLATION: This dolly set should only be installed by an adult with some experience in working with tools. To install the wheel set properly, you will need to drill 6 holes (5/16") in the plywood transom for the mounting brackets (3 holes per bracket). It is very important to locate the position of the holes correctly (2 holes at lower position, 1 hole at upper position). Please check carefully including checking the wheel arm position before starting to drill any holes. Maintenance: Wash it after using from salt water or sandy beach. Check tire pressure before every using. Don't store the wheels under the sun or beside the heat to maximize its life time. Take the wheel arm off from the transom bracket when store your boat. Lube the spring load dolly system is necessary. Keep the lock pin on the dolly bracket. Tire inflation: Dolly tires may not be fully inflated when shipping; please only give 15-20 PSI pressure at room temperature before using. Best to use portable type digital air pump in case tire over inflated. Tire over inflated will cause damage and the warranty is not covered. Dual wheel kit is available for this dolly for heavy loading application.
