Product Review

High-quality, "build-your-own" kit suitable for building multiple throttle cables for generally any motorcycle application.

The wires will need to be cut to length and the required nipples soldered into place.

PLEASE NOTE: We strongly discourage the use of a propane type torch to heat and flow solder into the wire. This is likely to overheat the wire, causing it to become brittle and break. We recommend immersing the wire ends in a molten solder bath, such as that in a solder pot.

The ferrules and adjusters are a snug fit. They may be bonded into place if preferred, or you can use a center punch to make a small indention in the side.

The kit includes:

5 meters (15 feet) of Teflon lined 5mm OD black PVC coated, spiral wound conduit

5 meters (15 feet) of 1.5mm OD galvanized steel wire (7 x 7 strand)

10 ferrules, 1/4" OD

20 ferrules, 5.5mm OD

20 ferrules, 5.5mm OD

1 mid-adjuster, 6mm x .75 x 20mm

5 brass barrel nipples, 5.75mm DIA x 5.5mm

20 brass carb nipples, 3mm DIA x 3mm

2 general use neoprene boots, 14mm ID

10 neoprene adjuster boots, 7mm ID