Product Review
Note: The color of the item may vary slightly due to photography and your own computer
Dual flush water-saving type: for all drainage you can adjust water in the water tank ; for half drainage,you can use the water in the water tank to adjust the silicone seal , it with good sealing effect ,will not have leaking.
Note:
1.This item only suitable for 65mm-75mm drainage hole.
Maximum for 78mm drainage hole ,Can NOT be used if it exceeds.
2.This toilet valve is not suitable for glacier bay
Material:ABS
Color:White
Height:approx.25cm/9.84inch (not include with the base height)
Total width:approx.11cm/4.33inch
Outer diameter of washer: approx.88mm/3.46inch
Base diameter (without the washer):approx.65mm/2.56inch
Weight:361g
Note: Need to confirm the following two points:
1. Toilet tank hole Diameter : Between 65mm -75mm (2.56inch-2.95inch)
2. Measure the Tank Height: Height Should Be 26cm-27cm (10.24inch-10.63inch)
Note : Measured From the Inside of the Water Tank
Otherwise , it won't fit.
Package Include:
1x Toilet Push Button Valve
- This item is only applicable to 65mm-75mm (2.56inch-2.95inch)Toilet tank hole Diameter. The maximum drainage hole is 78mm, and it cannot be used if it exceeds it.
- Measure the height of the water tank without lid: Height Should Be 26cm-27cm (10.24inch-10.62inch),Please measured From the Inside of the Water Tank, otherwise , it won¡¯t fit.
- Tips: please check the size in the second image before buying。Before buying, please measure the opening at the bottom of the toile tank and compare it to the diameter listed for this item.It has two Flush Buttons on top (high/low), so it would depend on your toilet tank lid depression pin alignment to this flush device as to which button would get depressed (maybe neither). Bigger question is whether the bottom nut and gasket are the same size as what toilet tank has.
- This toilet valve is not suitable for Glacier Bay.Easy to install, just remove your toilet tank from the toilet as it has a center shaft that goes through the bottom of the toilet tank and a large wing nut that can be screwed onto it to connect it to the toilet tank
- it replacement for OEM. need to adjust the plunger rod on the button for proper travel adjustment. This unit is slightly taller than Replacement for OEM parts, need to trim the stem a bit
- How to choose the right toilet valve? Determine toilet type: Determine whether your toilet is one-piece or two-piece. Differentiating Flush Valve Types: Learn about the different types of flush valves available. Measurements: Measure the dimensions of your current flush valve and toilet tank.
- Note: After receiving the product, you can install it according to the video and instructions. If you have any questions, please consult customer service
