Product Review

Important Tips for Drone: 1.The motors and circuit board will heat up with misuse. We suggest the users take a 10 minute cool down break between flights to ensure the parts last as long as possible. 2.To avoid being burnt up the USB Charger, it should be used under currents input 0.5A. 3.Don't push the throttle up hard directly. Adjust the throttle slowly to avoid damage caused by loss of control. 4.The weight of quad copter is less than 0.5lb and no registration is required for this model on FAA. Cautions for LiPo Battery Usage: 1)Don't use or charge a battery if it shows signs of swelling, pierced, or damaged in any way. 2)Don't charge the battery directly after use, allow it time to cool down in an open and dry area to insure overheating does not occur. 3)Please be away from furniture carpet or anything flammable. A fireproof bag is recommended for LiPo battery charge or storage. 4)Don't charge the battery above 0.5A. Make sure to remove the battery from the charger after charging is complete, never overcharge the battery. 5)Be cautious while removing a battery from the charger, it’s possible to strip the cords that could lead to a fire( and ruin the battery) Product Description: Model Number: F181 6-axis Gyro stabilization system makes the helicopter more stable and flexible when flying. It has the characteristics of wind-resistant and can be flied indoor or outdoor Includes: 1 x Quad Copter 1 x 2.4G Remote Transmitter 2 x USB charging cable 2 x 3.7V 750mAh LiPo Batteries 4 x Rotating blade 4 x Protection frames 2 x Landing skids 1 x Screwdriver 1 x User Manual For More Accessories, please search the assign below: Motors : B00Y84PH3Y Batteries:B00X9HIPVW 5 in 1 Battery Charger : B00QHUONLE Blades and other Spare Part:B00YDS36UQ Trouble shooting steps 1. Camera is red when it is taking picture or video and it is blue during the vacancy 2. This drone do not have the GPS function. Please read the page information carefully . 3. A fully charged battery can only last for 6-9minutes. The motors and circuit board will heat up with minutes. It is better to cool the motors down for 10 minutes between flights, ensure the parts last as long as possible.