Track Price :: Reviewing Millions of Products!

SeeedStudio - Bus Pirate v3.6 - Universal Serial Interface - DIY Maker Open Source BOOOLE
SeeedStudio - Bus Pirate v3.6 - Universal Serial Interface - DIY Maker Open Source BOOOLE
Disclaimer: As an Amazon Associate I may earn from qualifying purchases

Bus Pirate v3?is a universal bus interface that talks to electronics from a PC serial terminal. Get to know a chip without writing code. Eliminates a ton of early prototyping effort with new or unknown chips. A laser cut acr...

Buy Now From Amazon

Product Review

Bus Pirate v3?is a universal bus interface that talks to electronics from a PC serial terminal. Get to know a chip without writing code. Eliminates a ton of early prototyping effort with new or unknown chips. A laser cut acrylic case for Bus Pirate v3.6 is also available.

Protocols

1-Wire, I2C, SPI, JTAG, asynchronous serial (UART), MIDI, PC keyboard, HD44780 LCDs, and generic 2- and 3-wire libraries for custom protocols.

Features:

- USB interface, USB powered
- 5volt tolerant pins
- 0-6volt measurement probe
- 1Hz-40MHz frequency measurement
- 1kHz-4MHz pulse-width modulator, frequency generator
- On-board multi-voltage pull-up resistors
- On-board 3.3volt and 5volt power supplies with software reset
- Macros for common operations
- Bus traffic sniffers (SPI, I2C)
- Transparent USB to serial bridge mode
- 10Hz-1MHz low-speed logic analyzer
- Custom support in?AVRDUDE?,?Flashrom?,?OpenOCD
- AVR STK500 v2 programmer clone
- Scriptable from Perl, Python, etc.
- A bootloader for easy USB firmware updates
- Uses?DP6037 standard PCB layout
- Open source (CC 0/Public Domain)


  • USB interface, USB powered. 5volt tolerant pins. 0-6volt measurement probe. 1Hz-40MHz frequency measurement. 1kHz-4MHz pulse-width modulator, frequency generator. On-board multi-voltage pull-up resistors.
  • On-board 3.3volt and 5volt power supplies with software reset. Macros for common operations. Bus traffic sniffers (SPI, I2C). Transparent USB to serial bridge mode. 10Hz-1MHz low-speed logic analyzer. Custom support in AVRDUDE , Flashrom , OpenOCD.
  • AVR STK500 v2 programmer clone. Scriptable from Perl, Python, etc. A bootloader for easy USB firmware updates. Uses DP6037 standard PCB layout. Open source (CC 0/Public Domain).

Similar Products

JIUWU Test Hook Clip Ideal for Electronic ExperimentElegoo EL-CP-004 120pcs Multicolored Dupont Wire 40pin Male to Female, 40pin Male to Male, 40pin Female to Female Breadboard Jumper Wires Ribbon Cables Kit for arduinoZHIYUN interface cable designed for Bus Pirate V3,it has 10 clip probes and a 10 pin connector,good partner for Bus Pirate V3,can makes it easier to connect the Bus Pirate to a circuit and get hackingKeeYees USB Logic Analyzer Device with 12PCS 6 Colors Test Hook Clip Set USB Cable 24MHz 8CH 8 Channel UART IIC SPI Debug for Arduino ARM FPGA M100 SCMHiLetgo USB Logic Analyzer Device With EMI Ferrite Ring USB Cable 24MHz 8CH 24MHz 8 Channel UART IIC SPI Debug for Arduino ARM FPGA M100 SCMEDGELEC 120pcs Breadboard Jumper Wires 10cm 15cm 20cm 30cm 40cm 50cm 100cm Optional Arduino Wire Dupont Cable Assorted Kit Male to Female Male to Male Female to Female Multicolored Ribbon CablesHaitronic 120pcs 20cm Length Jumper Wires/Dupont Cable Multicolored(10 Color) 40pin M to F, 40pin M to M, 40pin F to F for Breadboard/Arduino Based/DIY/Raspberry Pi 2 3/Robot Ribbon Cables KiGlarks 112Pcs 2.54mm Male and Female Pin Header Connector Assortment Kit, 100pcs Stackable Shield Header and 12pcs Breakaway PCB Board Pin Header for Arduino Prototype ShieldHiLetgo ESP-WROOM-32 ESP32 ESP-32S Development Board 2.4GHz Dual-Mode WiFi + Bluetooth Dual Cores Microcontroller Processor Integrated with Antenna RF AMP Filter AP STA for Arduino IDE
Copyright © 2021 Track Price - All rights reserved