Product Review

Ultimate Bearing Kit for Dillon XL650 / XL750 kit includes the Shellplate Bearing Kit and the Camming Pin Bearing for eliminating the spills of powder when the shellplate indexes. Run out is minimized resulting in more consistent overall length of your ammo. This kit will make the operation of your press as smooth as silk. Our Camming Pin Bearing reduces friction and smooths the reciprocating action of the case insert slide and slide cam. The same pin diameter as OEM, allows the casefeed arm to function correctly. The hex cut into the end helps you properly align the bearing using an allen wrench. Our camming pins have a blued finish. We match the dimensions of the OEM pin. Our pin fully supports the casefeed arm, reducing vibrations and unnecessary wear. The ejector wire may require tuning, see our FAQ for details. Many users report more consistent and easier primer seating. This kit does not require re-adjustment of dies. Our Low Mass Detent Ball is tough as nails. This phenolic ball is super hard, smooth and lightweight. It's approximately 7 times lighter than the factory steel ball and every bit as tough. The low mass detent ball and reduced power spring has less momentum when it locks up with the shellplate. This detent ball is highly abrasion resistant and will not be cut or scared by the shellplate. Thumbscrews replace screws and bolts to speed up the adjustment of the press. Thumbscrews for 3 powder measures and 3 powder measure adjustment knobs are included. This configuration works with both new and old style powder measures. Minor fitting of provided nylon washers is required, it is easy to do and covered in the instructions. We maintain a FAQ with the latest tips and tricks for your press. You may want to check that out before purchasing a kit.