Product Review

Specification:
1.Suface: Surface paint treatment, anti-aging. To prevent the wiper turn into white in insolation
2.Material:Arm: Use 100% PBT with 30% Pb, It makes the wiper more hard,Blade: ABSP Rubber, AA level
Installation:
1 Joint the wiper arm with the cross-pillar, which is in the middle of the wiper blade
2. Put in vertical direction. The wiper arm would be stuck in the blade.
3 Install the whole kit in the window. Done
Attention : 1. Pls check the pic and make sure the wiper is you wanted.
2. Make sure all plastic/metal is removed from the wiper motor shaft or the new arm will not fit!!
How to solve the question when you find the "hole is small ?
1 VP customer told: The hole is smaller than the original one and it can't be put in,Looks like an exact replacement. Used a nutcracker/splitter to remove old sleeve from shaft of wiper motor. Easy installation after sleeve removed. A replacement nut and a dab of antiseize would have improve ease of installation".

2 VP customer told: Just received this replacement arm and had to do a bunch of digging around to figure out how to make it work. The hole that slides over the shaft is smaller than the original because the shaft on my vehicle had a knobby collar pushed onto it that the original arm hole fit over. Apparently there is/was a design change and this collar must be removed to make this new replacement arm work. After reading through Dodge forums I found someone with the same issue who said he used a hack saw or a dremmel to cut the sleeve, top and bottom, and it came off in two pieces. I gave it a try and it worked like a charm. After, the new arm fit perfectly and I just had to tighten up the nut.