Product Review

LED Strip Connector for 4 Pin RGB 5050 LED Strip Lights, DIY Strip to Power Lead or Strip to Strip Jumper, Terminal Only, 20AWG Wire No Included (Pack of 10)
NOTE: 1.Make sure your section of led light strip is 10mm wide 4 pin IP65 WATERPROOF RGB LED Strip.
2 .Ensure your Wire Diameter 20AWG /0.34~0.54 mm2 (exclude silicon wire) and without stripping wire.

Firmly bite the strip, no need to peel back the silicon cover
Updated version of LED strip connectors, assemble wire by yourself as needed, flexible to different project! No need to solder. Just clasp your prepared led strip section into the connector to get connected. Connect waterproof LED strip without removing surface coating silicon gel, compatible with 30-120 LEDs/M strip, made of flame retardant material, safely use. Support high current LED strip lights.

Installation TIPS:
Strip End:
1. cut the strip straight perfectly, then fully open the clip.
2. push the strip in until it hits the backing, and pins on the connector make contact, and press hard down for several times with nose pliers to make sure the PINS puncture through the strips.
Wire End:
1. have to be separated the 4 wires (20AWG) before you insert them into the connector.
2. required to press down hard for several times with nose pliers! Ensure the contacts pierces through the insulation on the wire as there are so many non-standard wires on the market!
3. reminder: no stripping of the wires. Just be sure polarity nodes are matched up "+" to "+" and "-" to "-".
If you have any problem about installation, pls feel free to contact me.

Package:
10pcs Strip to Wire Connectors (AC-DJ-N10XB-4)