If you have a joint going bad on your vehicle because of overheating that caused the axle to seize in the hub. the ABN Axle Remover & Front Wheel Puller Hub Grappler is your solution. This tool has a universal, flange type d...

Buy Now From Amazon

Product Review

If you have a joint going bad on your vehicle because of overheating that caused the axle to seize in the hub. the ABN Axle Remover & Front Wheel Puller Hub Grappler is your solution. This tool has a universal, flange type design for all vehicles with independent front wheel suspension. If your vehicle's studs are inside (not outside or on) the drum (hub) and has a tapered axle and 4-6 lugs, this puller is for you. It removes wheel hubs mounted on tapered axles and press fit rear drum brakes by pushing on the end of a shaft. It will not distort wheel lugs and will provide a straight pull. The bolt presses against the axle to pull the hub off, but if you look closely, you will see that it is tapered, so it will not damage the axle. WARNING: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

  • EASY BRAKE & BEARING REPAIR: The ABN Axle Remover & Front Wheel Puller Hub Grappler Tool makes for easy brake and bearing maintenance
  • WORKS ON YOUR VEHICLE: Compatible fit on domestic and import vehicles with independent front wheel suspension; Use on any vehicle with studs that are inside the drum and has a tapered axle and 4-6 lugs
  • VARIOUS APPLICATIONS: Use this hub grappler on 4, 5, or 6 bolt stud design and all non-C lock GM axles
  • BUILT TO LAST: Heated pressure screw holds up to tough use; Drive center hole for the wheel studs and are constructed from heat-treated alloy steel that is drop forged for maximum strength and longevity that resists rust and corrosion
  • PERFECT SIZE: Yoke and bolt are threaded 5/8-inch x 18 inches to best suit most vehicle applications

Similar Products

OTC (1155) Basic Slide Hammer Unit - 5 lbs. HammerGEARWRENCH Universal Ball Joint Separator - 3916D8MILELAKE 9 Way Slide Hammer Axle Bearing Dent Hub Gear Puller SetHFS (R 23-Pieces FWD Front Wheel Drive Bearing Adapters Puller Press Replacement Installer Removal Tool KitTruePower 20-2029 Universal Hub PullerBeck Arnley 103-0504 Axle NutsOEMTOOLS Tools 27308 Adjusts from 1-1/8” to 2-1/8” | Fits Common Ball Joint Sizes | Steel Separator Mechanism w/Black Oxide Pin | 7/8” Fork Opening| Comes w/CaseATD Tools Wheel Hub Removal Tool (ATD-8629)EPAuto 1/2-Inch Drive Click Torque Wrench (25-250 ft.-lb. / 33.9-338.9 Nm)Dorman 615-224 M22-1.50 Hex Star Pattern Spindle Nut, Pack of 2