Product Review

This bridge dent puller kit system works by hot melt gluing a threaded plug to the car metal, usually to the center of the dent. A hot melt glue gun and glue are not included in the pack. A flexible bridge is then placed over the plug and a knob placed onto the threaded plug. Turning the knob slowly draws the plug away from the metal. As the glue has set in the concave shape of the dent, it releases when the dent 'pops' out.
Great product that allows you to remove car dent in three easy steps.
1.Clean damage surface with a damp clean cloth, put the glue to gun and heat(also it need about 5-10min )
2.Pull the trigger and apply the drawing gasket with extruded glue (The holes of gasket should be applied with hot melt glue)immediately place pad in the center of the dent and hold until sticks
3.Place stem of pad through hole pulling bridge and screw knob,tighten knob until pad pops off and clean the surface.

Dent Puller Tools includes:

- 9" Bridge (5-1/2" clearance between pads)
- 1-3/8" diameter round puller
- 1-1/8" diameter round puller
- 1" diameter round puller
- 15/16" diameter round puller
- 1-1/4 x 3/4" Oval puller
- 1 knockdown