Product Review

Tips need to notice:
1. Find the dent by the line board ( through the refraction of light )and clean it with rag and alcohol.
2. Then clean the glue stick with alcohol to remove the grease on its surface.
3. Insert the glue into the glue gun and connect the gun to the power supply , then heat it about 2-5 minutes until there is some hot glue spilling out from the gun.
4. Choose a tab whose shape is the most similar to the dent and pay attention to the hot glue which should begin from the centre of the tab , and with the circle action to smear it cover the tab, but should not overstep .
5. You should quickly paste the tab to the dent and press it until the hot glue is firmed . ( It is the best time to use and the strongest viscosity the glue has when the hot glue will cool but still has a little remaining temperature , it needs about 0.2-5 minutes that you could feel it by hand.)
6. Fasten the Dent Lifter or T-shaped Repairer or Hammer or Bridge Puller and hold its two handles, up and down with power gradually , repeat your action until the dent is repaired or flatted , and don't let the tab go off the car body. What's more, you should pay attention to your power and not be rushed .
7. After repaired, spray the adhesive remover on the part where covers glue and remove it with a scraper .
8. Check the repair effect again, if not very well , please repeat the above steps until be repaired. Recommend these tools. DIY is much cheap than body shop.

Packing list
21pcs PDR RODS (5A+10B+6C)
1pc PDR Line Board
1pc Dent Lifter
1pc 100W Glue Gun
1pc Metal Tap down with 9 heads
5pcs Tap Down
10pcs Pro Glue Sticks
20pcs Pro Tabs
1pc T-bar
1pc Tap Down Hammer
1pc Rubber Hammer
1pc Slider Hammer Lifter
1pc Bridge Puller with 7 Pulling Tabs
1pc tool bag
1pc Yellow shovel
1pc bottle
1pc blue clean cloth