Product Review

How to use this paintless dent repair kits?

1.Clean the dent with a clean wet cloth;
2.Mount the glue stick into the glue gun,pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes;
3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is);
4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);
5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter);
6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;
7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen;
8. Clean the repaired place with a clean wet cloth.

Package:
12pcs black rods
11Pcs blue rods
6pcs yellow tap down tools
1pcs rubber hammer
1pcs reflect board
1pcs air wedge pump
2pcs Chains
2pcs rings
2pcs hooks
1 pcs tool bag
10pcs glue sticks
1pcs 100W glue gun
1pcs dent lifter
1pcs melt tap down tool with 9 heads
27pcs pdr puller glue tabs
1pcs Instructions
NOTE:
DO NOT let the glue harden completely. It will just break off when pulling the dent. As we pull the dent we should see the glue stretch slightly, and there will be a distinctive metal popping sound if we do it properly.