Product Review
Industrial Water Cooling Chiller for CO2 Laser Tube Engraver Cutting Cutter CW5000 DG
Introduction :
The CW-5000DG Chiller is popular for cooling CNC and Laser machines.It is designed for cooling the one CO2 glass laser tube under 80W/100W of the laser engraving and cutting machine. Emitting rate higher than 60%.Under normal circumstance,the new intelligent temperature controller does not need to adjust the controlling parameters.
Technical Data
Voltage:110V
Frequence: 60HZ
Current: 3.5~5.6A
Tank Capacity: 6L
Compressor Power: 0.305KW, 0.41HP
Refrigerating Capacity: 2866Btu/h, 0.84KW, 722Kcal/h
Refrigerant: R-134a
Refrigerant Charge: 280g
Precision: ±0.3℃
Reducer: Capillary
Pump Power: 0.03KW
Maximum Flow: 10L/min
Maximum Pumping Lift: 10M
Inlet and Outlet: External Φ10mm brass connector
Protection: Flow alarm
Install steps:
A.Open the package to check if the machine is intact and all the necessary accessories are completed
B. Open the injection port to feed cooling water
C. According to system conditions, please well connect water inlet and outlet pipe
D. Plug in, turn on the power switch. (Do not start up without water in the tank!)
E. Check the water level in the water tank
F. Adjust parameters of temperature controller
Features1.±0.3℃ precisely temperature control
2.800W cooling capacity; use environmental refrigerant
3.Compact size, long working life and simple operation
4.The intelligent temperature controller has 2 control modes, applicable to different applied occasions; with various setting and display functions
5.Multiple alarm functions: compressor time-delay protection, compressor overcurrent protection, water flow alarm and over high / low temperature alarm
