The product can control the soil humidity in a wide range,adjusting the potentiometer to control the corresponding threshold,when the humidity is lower than the set value,Digital Output the high level,and higher than the ...

Buy Now From Amazon

Product Review

The product can control the soil humidity in a wide range,adjusting the potentiometer to control the corresponding threshold,when the humidity is lower than the set value,Digital Output the high level,and higher than the set value,Digital Output the low level.

Product description:
Operating voltage: 3.3V-5V
PCB size:3.2*1.4cm
Wiring instructions(three-wire):
1.VCC:3.3-5V
2.GND:GND
3.DO:digital output interface (0 and 1)
10pin female to female DuPont cable
20pin male to female DuPont cable


The soil moisture module is generally used to detect the moisture content of the soil. The blue potentiometer is used to adjust the threshold of the soil humidity,when clockwise to adjust,the humidity will be higher,the anticlockwise will be lower.
The digital output D0 can be connected directly with the microcontroller to detect high level and low level by the microcontroller to detect soil moisture.

Package list:
Soil Moisture Sensor Module*5 pcs
10pin female to female DoPont cable
20pin male to female OoPont cable



  • Kuman soil moisture module,the surface using nickel-plated treatment,widened sensor area,can improve the electrical conductivity,to prevent touch the soil is easy to rust,and increase of service life
  • Through adjusting the potentiometer to control the soil humidity threshold,can automatic watering the vegetable garden, garden, control the flower pot soil moisture, all of electronic competitions and for the Arduino Raspberry pi design etc
  • This is a must have tool for a connected garden! It will be helpful to remind you to water your indoor plants or to monitor the soil moisture in your garden
  • Kuman soil moisture module kit have 10pin female to female DuPont cable and 20pin male to female DuPont cable for Raspberry pi 3 PI 2 RPI 1 model B+ B Arduino Mega 2560
  • The example project of the Soil Moisture Sensor Module working with Arduino and Raspberry pi can be provided free by Email, please contact us via Amazon

Similar Products

HiLetgo 5pcs DHT11 Temperature Humidity Sensor Module Digital Temperature Humidity Sensor 3.3V-5V Humidity Measure Range 20%-95% Temperature Measure Range 0-50℃ Celsius with Dupont WiresMicrochip MCP3008-I/P 10-Bit ADC with SPI (Pack of 4)JBtek 4 Channel DC 5V Relay Module for Arduino Raspberry Pi DSP AVR PIC ARMDecdeal Submersible Water Pump DC 12V 5W Ultra-quiet Pump for Pond, Aquarium, 280L/H Lift 300cm12V Plastic Water Solenoid ValveAdafruit MCP3008 8-Channel 10-Bit ADC With SPI Interface for Raspberry PiGikfun Capacitive Soil Moisture Sensor Corrosion Resistant for Arduino Moisture Detection Garden Watering DIY (Pack of 2PCS) EK1940SainSmart 4-Channel Relay ModuleGowoops 2 PCS DHT22 Temperature Humidity Sensor Module Digital Measurement for Arduino Raspberry Pi 2 3DFROBOT Gravity: Analog Capacitive Soil Moisture Sensor- Corrosion Resistant