NOTE:

1. When energized, do not connect to the motherboard or replace the different module interfaces.
2. Pay attention to the Positive and negative of the wire.
3. Please check to determine whether ...

Buy Now From Amazon

Product Review

NOTE:

1. When energized, do not connect to the motherboard or replace the different module interfaces.
2. Pay attention to the Positive and negative of the wire.
3. Please check to determine whether the connection interface is correct, so as not to damage the motherboard before open telegram.
4. When in emergency occurs, please press the RESET button on the motherboard or disconnect.
Package Included:

1pcs * Controller Board
1pcs * USB


  • The power buck chip using XL1509 chip, high efficiency, stability. Short circuit protection, 150KHz fixed switching frequency 2A current input 12 ~ 40V input voltage.
  • USB serial chip using CH340T chip, the largest 2Mbps, communication Stable, to solve the streamlined version of the Windows driver cannot be installed Problem, support for a full range of Windows, mac, liunx operating system.
  • The processor uses tamega2560 chip, 54 output to meet the various Output Interface.
  • Tantalum capacitor filter acquisition temperature, anti-interference, more accurate.
  • Heatbed MOS tube with F8736 chip, the maximum 18A current.

Similar Products

5x StepStick DRV8825 Stepper Motor Driver Module for 3D Printer Reprap RP A4988BIQU A4988 Compatible Stepper StepStick Motor Diver Module with Heat Sink for 3D Printer Controller Ramps 1.4(Pack of 5pcs)GeeBat 460pcs 2.54mm JST-XH Connector Kit with 2.54mm Female Pin Header and 2/3 / 4/5 / 6 Pin Housing Connector Adapter Plug (JST Connector Kit)KINGPRINT DRV8825 Stepper Motor Driver Module with Heat Sink for 3D Printer Rrerap Ramps 1.4 A4988 (Pack of 5pcs)BIQU Heat Bed Power Module Expansion Hot Bed MOS Tube for 3D PrinterWINSINN Leveling Spring Component - M3 Screw Knob - for 3D Printer Hot Bed/Platform (Pack of 4set)OctagonStar Flexible Couplings 5mm to 8mm NEMA 17 Shaft for RepRap 3D Printer or CNC Machine(2PCS)ANTCLABS BLTouch : Auto Bed Leveling Sensor/To be a Premium 3D Printer (With 1M Extension Cable Set)Genuine E3D V6 Socks Pro (Pack of 3) (V6-SOCK-PRO-3PACK)Gowoops 5 PCS of Mechanical Endstop Switch with Cable for 3D Printer Makerbot Prusa Mendel RepRap CNC Arduino Mega 2560 1280