Product Review

3 steps to use EL-50588 GM CHEVROLET TPMS Relearn Tool

Before the tire pressure monitoring system works properly, the body control module will record ID information of each position in the tire pressure sensor; and follow the below method to read the tire pressure sensor after replacing a tire or wheel speed sensor.

Step 1 - Enter leaning mode
Set the gearshift lever to "P"
Turn the ignition switch to "ON"
Enter the interface of tire pressure display by DIC
DIC shows "Press Set / Ctrl to re-learn"
Press "Set / Ctrl"
The turn signal lights for 3 seconds and the horn beeps twice to enter the learning mode

Step 2 - Read the tire pressure sensor information of front-left wheel

TPMS Relearn Tool EL-50588 antenna up against the valve core position & close to the rim of the tire sidewall.
Start the switch of El-50588 tire pressure tool, when the horn beeps once, it successful to read the tire pressure sensor information
Step 3 - read the other tire pressure information in the same method

Follow the instruction above to read the tire pressure of the front-right, rear-right, rear-left wheels.
The turn signals lights for 3 seconds and the horn bleeps twice when the learning complete.