Product Review

Compatible Vehicles:
2010 Chrysler PT Cruiser Classic Wagon 4-Door
2010 Chrysler PT Cruiser Couture Edition Wagon 4-Door
2009/ 2008/ 2007/ 2006/ 2004/ 2003/ 2002/ 2001 Chrysler PT Cruiser Base Wagon 4-Door
2009/ 2008 Chrysler PT Cruiser LX Wagon 4-Door
2009/ 2008/ 2007/ 2006/ 2005/ 2004/ 2003/ 2002/ 2001 Chrysler PT Cruiser Touring Wagon 4-Door
2008/ 2005 Chrysler PT Cruiser Touring Convertible 2-Door Chrysler PT Cruiser Touring Convertible 2-Door
2007/ 2006/ 2005/ 2004/ 2003/ 2002/ 2001 Chrysler PT Cruiser Limited Wagon 4-Door
2007/ 2006/ 2005/ 2004/ 2003/ 2002/ 2001 Dodge Caravan SE Mini Passenger 4-Door
2006/ 2005 Chrysler PT Cruiser Street Cruiser Wagon 4-Door
2006/ 2005/ 2004/ Chrysler Sebring Base Convertible 2-Door
2006/ 2005/ 2004/ Chrysler Sebring Base Sedan 4-Door
2006/ 2005/ 2004/ 2003/ 2002/ 2001 Dodge Stratus SE Sedan 4-Door
2006/ 2005/ 2004/ Dodge Stratus SXT Sedan 4-Door
2005 Chrysler PT Cruiser Dream Cruiser Wagon 4-Door
2005 Chrysler PT Cruiser GT Convertible 2-Door
This is Non-OEM product, accessory only!Replacement procedure. （Take "2005 PT Cruiser 2.4L" as an example）
Step ①: Remove the six 8mm upper manifold retaining bolts.
Step ②:Loosen the air intake clamp at the throttle body.
Step ③:Lift the upper intake manifold and retain out of the way using a bungee cord.
Step ④:Remove old plug wire.
Step ⑤:Using cotton swab, apply a very small amount of dielectric grease to the boot interior at each end (just the boot - not the terminal).
Step ⑥:Reinstall new plug wire.
Step ⑦:Repeat for each cylinder until done.
Step ⑧:Lower intake manifold back in place and tighten to spec from interior bolts to the outside (no new gaskets required).
Step ⑨:Tighten clamp at air intake to throttle body.