Product Review

SURFACE MOUNT INSTALLATION
Step1) Prior to installation. Please install two screws (furnished)into the junction box. Do Not drive screws completely to the end of the junction box.
Step2) Connect supply wires to wires in fixture wiring box with proper size wire nuts or push wires into "push-in" connector. Connect white to white, black to black, and green or bare copper wire to bare copper wire.
Step3) The ground wire at the service junction box may need to be secured to a ground screw.
Step4) With a Phillips screwdriver, attach the disk light tightly to the j-box.
Step5) Complete the installation by twisting the diffuser on the disk light aluminum enclosure and lock the diffuser in place.
Step6) The edge of the fixture and the ceiling use waterproof silicone to seal.

WARNING:
For your safety read and understand instructions completely before staring instructions. Before wiring to power supply, turn off electricity at the fuse or circuit breaker box.

1.Risk of Fire
Supply conductors (power wires) connecting the fixture must be rated minimum 90℃. If uncertain, consult an electrician

2.Risk Of Electric Shock
Disconnect power at fuse or circuit breaker before installing or servicing

3.Risk Of Fire/Electric Shock
If not qualified, consult an electrician

CAUTION
THIS PRODUCT MUST BE INSTALLED IN ACCORDACE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED