Product Review

Geared Stepper Motor of TIMESETL

TIMESETL Arduino Motors - High Quality
Specification:
Stepper motor
Diameter: 1.1 inch (28mm)
Voltage: DC 5V
Length: 9.5 inch (23.9cm)
Step Angle: 5.625 * 1/64
Reduction ratio: 1/64
DC Resistance: 200¡À7% (25)
Insulation Resistance: >10M (500V)
Dielectric Strength: 600V AC / 1mA / 1s
Insulation Grade: A
No-load Pull in Frequency: >600Hz
No-load Pull out Frequency: >1000Hz
Pull in Torque: >34.3mN.m(120Hz)
Detent Torque: >34.3mN.m
Temperature Rise: <40K(120Hz)
Noise: <40dB (120Hz, No load, 10cm)

Uln2003 driver test module: size 1.4 x 1.3 x 0.4 inch (3.5*3.2*1 cm)
Hole diameter: 3mm

Jumper wires male to female: 20cm/8inch length

TIMESETL Arduino Stepper Motor - Easy To Use

The stepper motor is a standard 4 phase design and is very easy to use.

Comes with an easy to use 5 pin connector attached to the end, keyed to ensure you do not connect it to the motor driver board backwards.

There is an LED for each output pin - this makes it easy to see which phases are currently active.

This stepper motor is bi-directional - you can run it clockwise or anti-clockwise.
To run the motor clockwise, you should activate the phases in this order:
Phase D
Phase D and Phase C
Phase C
Phase C and Phase B
Phase B
Phase B and Phase A
Phase A
Phase A and Phase D
And repeat...

To run the motor anti-clockwise, you should activate the phases in this order:
Phase A
Phase A and Phase B
Phase B
Phase B and Phase C
Phase C
Phase C and Phase D
Phase D
Phase D and Phase A
And repeat...

Delivery
5pcs x Driver Board
5pcs x Stepper Motor
40pin x Female Male Dupont Wire