Product Review

innhom Heat Gun

Specifications:
Color: Black
Material: ABS
Size: 228*44mm / 9*1.7in
Wire length: 80in (200cm)
Type: Constant temperature
Working temperature: 200°C-300°C /392°F-572°F
Power type: AC power supply
Rated voltage: 110V
Rated frequency: 50Hz
Rated power input: 300W

How to use the heat tool
1. Plug in power and turn on the heat tool.
2. Hold the product as shown in the picture, DO NOT touch the hot nozzle. 3. Keep 2"-3" (5-8cm) distance between the heat tool and the stuff needed heating.
4. Turn off the power and wait until it is cool completely.
5. To prevent overheated, DO NOT use more than 10 minutes continuously.

Notes:
1. This kind of gun can not adjust the temperature but it heats up quickly at about 200°C theoretically.
2. Therefore do not blow your Polymer Clay Works at one position for a long time to prevent distortion.
3. This heat gun is not a High Power one due to it's 300W low power. But it is great for heating shrinkable film, embossed powder, rubber stamp, the best choice to replace toaster or oven and the polymer clay will become hard and bright after using the gun.