Product Review

Intelligent Pulse Repair Battery Charger
Parameters: 1. Input Voltage: 110-230V
2. Output voltage: 12V/24V
3. Current:10A peak for 12V,8A peak for 24V
4. Suitable capacity: 30-120AH
5. Power:120W
6. Frequency: 50-60HZ
7. Length of output wire:65cm
8. Length of input wire:125cm
9. Dimension: 14*19*7cm
10. Gross weight: 0.9kg
11. Application: best suitable for 40-120AH lead acid batteries(including wet and dry)
Multiple protections
Overheat protection: The charger will close automatically without current output for protective purpose when its temperature is over 105℃, and when the temperature is decreased below about 80℃ or power supply is shut down for 10 minutes, charging process can be resumed.
Short circuit protection: In case of accidental short circuit, the charger will close automatically without current output, and beep for alarming. Once correctly connected, charging process will be resumed.
Reverse connection protection: Whenever positive poles and negative poles of the charger and the battery are not connected correctly, the charger will close automatically without current output, and beep for alarming. Once correctly connected, charging process will be resumed.
Low voltage protection: When single cell voltage is below 1.5V, the charger can not be started up, and beep for alarming. This mechanism is to avoid possible damages caused up by voltage discrepancy between the battery and the charger.
Please note: When two 12v batteries are charged together in series, if one battery voltage is too low, the total voltage is lower than 18v, the charger may not recognize that it is a 24V battery, and may stop charging. The solution is use 12V charge the low voltage first. when the total voltage over 18v, then use 24V charged them together.