Product Review
Cutting instructions
1.Create your design in mirror image
2.Place vinyl in the cutting machine with carrier sheet(glossy side)down
3.A test cut is recommended to determine correct settings for your machine
4.Weed excess vinyl so that you see your design on dear carrier sheet
Preparing your garment
1.set your iron to cotton or highest setting(no steam)
2.Place your garment on a flat hard surface
3.Preheat your garment for 5-8 seconds with iron
4.Posltion the transfer on garment.so carrier sheet (glossy side)is facing up
5.Place included teflon sheet over design
Application instruction (iron)
1.apply heat to entire area of transfer PRESSING FIRMLY for 20-25 seconds PER AREA you may need to repeat this process several times until you are sure the transfer has adhered to the garment (do not slide iron)
2.Life your iron and remove the teflon sheet
3.Allow transfer to cool for 45 seconds before peeling off clear carrier sheet
4.If transfer is sticking to carrier sheet or if design lifts off garment repeat steps 1-3
Application instructions(heat press)
1.set heat press to 300℉-320℉
2.Heat garment with medium pressure(20-30lbs)for 2-3seconds
3.Position transfer on garment so carrier sheet (glossy side) is facing up@cover with included teflon sheet
4.Apply pressure to garment (30-35ps) for 10-15 seconds
5.Allow transfer to cool before peeling off clear carrier sheet
Care instructions
1.wait 24 hours before washing
2.Wash garment inside out
3.Do not bleach or dry clean
4.Hang garment to dry.if you must place it dryer.make sure to turn garment inside out and use lowest setting
5.Do not iron directly over heat transfer material
Cautions
Always exercise caution when using an iron or heat press. keep HTV out of reach of children










