Micro Swiss All Metal Hotend Kit for Creality CR-10 / CR10 / CR10S / Ender 2 / Ender 3 Printers .4mm

Product Review

Mega 2560 & Ramps 1.4 are integrated in the board,which is designed to avoid complicating connections.
Support motor drivers such as 4988,8825,TMC2100 , and the driver is changeable
Reserved external driver signal, which is able to connect an external high-current driver to drive the 57,86 motor.
Use high quality MOSFET tube, have better cooling effect and be more stable.
Use special power chip,support 12-24V input, to solve the problems of chip heating and power shortage.
Stable and reliable filter circuit, reducing the possibility of interference and avoiding crash during printing.
Use CH340 serial port chip, easier to install the driver than 16U2.
Run Marlin firmware, be able to directly replace the Ramps 1.4.
Support direct connection of 2004LCD,12864LCD,TFT28 and TFT32.

You will get:
1x MKS Gen-L V1.0 3D Printer Controller Board.
1x USB Cable.

ATTN: Do NOT insert or pull the motor or driver under the condition of power-on, or the driver might be burnt out. Similarly, do NOT adjust the current when the motor is working.
Plug the driver according to the color of the terminals
Fits Model: MKS Gen-L V1.0
Must disconnect the power first, then remove the motor, re-power, and adjust the potentiometer(make sure the voltage on the potentiometer is the same as expected.) Do not insert the reverse drive, or it will damage the drive, even damage the motherboard.
Motor driver is NOT included in this product.

Track Price :: Reviewing Millions of Products!

XtremeAmazing New MKS Gen-L V1.0 3D Printer Controller Board Replacement Ramps 1.4 Mega 2560 R3

Product Review