Product Review

Installation:
1.Install the pillar, tighten the screw.
2.Install the demension ruler.
3.Release the wire, make the wire pass through the hole.
4.And then pass through the board hole, and let it buckle in the spring.
5.Turn on the power switch.

Note:
-Heating wire temperature can be adjustable, cutting different density and material need to adjust the appropriate temperature cutting.
-Usually, the electric wire is not red or slightly red is suitable. It can not be cut if the wire is very red.
-When cutting, the wire temperature is very high, should keep away from flammable and explosive materials.
-It is recommended to wear work glove when cutting.
-When complete cutting, please cut off the power in time.
-Some material may have a smell when cutting, it is recommended to cut in the ventilation environment.

Description:
- With adjustable temperature, heat up to approximately 300 degrees Fahrenheit under one minute.
- This foam cutter cut foam, sponge and also cut round shape (Dia.=340mm).With the regulator, the support could adjust 360 degree to let foam easily to cut. And it could work consistently.
- Brush to clean the hot wire.
- Screwdriver to install and remove wire from the unit.

Specification:
- Name: Table Foam Cutter
- Voltage: 110V
- Power: 30W
- Temperature Range: 50-300 degree C
- Max. Cutting Height: 20cm

Package Included:
- 1 X Table Foam Cutter
- 1 x Power Cable
- 1 x Cutting Wire (installed on the rail)
- 1 x Wrench