Product Review

The throttle position sensor gives information to the ECM (Engine Control Module) about the position of the pedal determining the speed at which the driver is pushing on the accelerator pedal. It is located at the front driver side of the engine inside the bell crank assembly housing in between the cylinder head and batter.

If your Dodge Ram is having problems in idling, speed falls off suddenly, check engine light pops up you are getting codes P2121, P0121, P0122, P0123 then you may have a problem with your throttle position sensor.

In order to properly install the replacement sensor, be sure the voltage of the TPS is set to 0.55v+ before locking in its position. Once set, turn the engine on and slowly push the accelerator pedal to the floor and back (only once) to make sure that the ECM learns the TPS calibration.

Fits the Following Vehicles:

1998-2003 Dodge Cummins 5.9L ISB with VP44

2003-2004 Dodge Cummins 5.9L ISB with Common Rail

1998-2007 Dodge Ram 2500 5.9L 359Cu. In. l6 DIESEL OHV Turbocharged

1998-2002 Dodge Ram 2500 5.9L 360Cu. In. V8 GAS OHV Naturally Aspirated

1998-2002 Dodge Ram 2500 5.9L 5899CC 360Cu. In. V8 GAS OHV Naturally Aspirated

1998-2002 Dodge Ram 2500 5.9L 5899CC 360Cu. In. V8 GAS SOHC Naturally Aspirated

1998-2007 Dodge Ram 3500 5.9L 359Cu. In. l6 DIESEL OHV Turbocharged

1998-2002 Dodge Ram 3500 5.9L 360Cu. In. V8 GAS OHV Naturally Aspirated

1999 Dodge Ram 3500 5.9L 5899CC 360Cu. In. V8 GAS OHV Naturally Aspirated

Replaces Part Numbers:

53031576, 53031576AD, 3970085, AP63427, 53031575, 53031575AH, 3970084, AP63428, 56028184A

Quality Guarantee:

10-Year Warranty