1. 100% Quality Guarantee;
2. Model:NRF24L01;
3. nRF24L01 is a single chip radio transceiver for
the world wide 2.4 - 2.5 GHz ISM band.
4.The transceiver consists of a fully integrated
frequ...

Buy Now From Amazon

Product Review


1. 100% Quality Guarantee;
2. Model:NRF24L01;
3. nRF24L01 is a single chip radio transceiver for
the world wide 2.4 - 2.5 GHz ISM band.
4.The transceiver consists of a fully integrated
frequency synthesizer, a power amplifier, a
crystal oscillator, a demodulator, modulator and
Enhanced ShockBurst? protocol engine.
5. Output power, frequency channels, and
protocol setup are easily.
6. programmable through a SPI interface. Current
consumption is very low, only 9.0mA at an output
power of -6dBm and 12.3mA in RX mode.
7. Built-in Power Down and Standby modes
makes power saving easily realizable.
8. Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability,
Particularly suitable for industrial control
applications.
9. 125 Communications channels, Multi-point
communication and frequency hopping to meet
the communication needs.
10.Built-in hardware CRC error detection,
Multipoint communication address control.
11.Low-power 1.9 ~ 3.6V, only 1uA on Power down mode.
12.Built-in 2.4Ghz antenna.
13. Available software to set the address, only
received local Address when output data(Provide
interrupt instruction), can be directly connected
to a variety of microcontrollers, Software
programming is very convenient.
14. Support 6 Data channels of data reception.
15. Standard DIP Pitch Interface for embedded applications.

Product Contents:
10 pieces of NRF24L01 + 2.4GHz RF Wireless
Transceiver Module

Please Note:
1). Please check pictures for more details.
2) Transceivers integrated module , transmit or
receive can not be simultaneously by one module.
3). If you have any questions during use, please feel free to contact our service personnel. We will do our best to give you a satisfactory answer.    

  • Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications.
  • 125 Communications channels, Multi-point communication and frequency hopping to meet the communication needs.
  • Built-in hardware CRC error detection, Multipoint communication address control. Built-in 2.4Ghz antenna.
  • nRF24L01 is a single chip radio transceiver for the worldwide 2.4 - 2.5 GHz ISM band. Compatible with Arduino and Raspberry Pi.
  • Applications: wireless peripherals, remote control systems such as RC vehicles and consumer remote electronics, wireless voice transmission such as VoIP, wireless sensor networks, wireless networks, home and commercial automation.

Similar Products

ELEGOO for Arduino Nano V3.0, Nano Board CH340/ATmega328P Without USB Cable, Compatible with Arduino Nano V3.0 (Nano x 3 Without Cable)IZOKEE Redesign Pro Mini ATMEGA328P 3.3V 8MHz Replace ATmega128 Module Development Board Microcontroller for Arduino PRO Module (3x New Design 3.3V 8MHz)Elegoo EL-CP-004 120pcs Multicolored Dupont Wire 40pin Male to Female, 40pin Male to Male, 40pin Female to Female Breadboard Jumper Wires Ribbon Cables Kit for arduinokuman 3 pcs nRF24L01+PA+LNA Antenna Wireless Transceiver RF Transceiver Module for Arduino KY67Paxcoo 4 Pieces Breadboards Kit with 120 Pieces Jumper Wires for Arduino Proto Shield Circboard PrototypingLongruner 3pcs Wireless Transceiver Module 2.4G 1100m NRF24L01+PA+LNA in Antistatic Foam for Arduino Compatible with Antenna LKY67Paxcoo 62Pcs PCB Board Kit Includes 32Pcs Double Sided Prototype Boards, 20Pcs Header Connector and 10 Pcs Screw Terminal BlocksARDUINO UNO R3 [A000066]ELEGOO 6PCS 170 tie-Points Mini Breadboard kit for ArduinoElegoo EL-CB-001 UNO R3 Board ATmega328P ATMEGA16U2 with USB Cable for Arduino