Product Review

LED Strip Connector 2 Pin 8mm - DIY Strip to Wire Quick Connection for SMD 3528 2835 Led Strip Lights(Pack of 10)
NOTE: 1.Make sure your section of led light strip is 8mm wide 2 pin IP20 Non-WATERPROOF LED Strip.
2. Ensure your Wire Diameter 20AWG /0.34~0.54 mm2 (exclude silicon wire) and without stripping wire.
3. Need to peel off the silicone on the surface of led lights when you want to connect WATERPROOF LED strip light.

DIY Strip to Wire Quick Connection 
Updated version of LED strip connectors, assemble wire by yourself as needed, flexible to different project! No need to solder. Just clasp your prepared led strip section into the connector to get connected. Connect waterproof LED strip need to peel off the silicone on the surface, compatible with 30-120 LEDs/M strip, made of flame retardant material, safely use. Support high current LED strip lights. 

Installation TIPS:
Strip End:
1. cut the strip straight perfectly, then fully open the clip.
2. push the strip in until it hits the backing, and pins on the connector make contact, and press hard down for several times with nose pliers to make sure the PINS puncture through the strips.
Wire End:
1. have to be separated the 2 wires (20AWG) before you insert them into the connector.  
2. required to press down hard for several times with nose pliers! Ensure the contacts pierces through the insulation on the wire as there are so many non-standard wires on the market!
3. reminder: no stripping of the wires.  Just be sure polarity nodes are matched up "+" to  "+" and "-" to "-".
If you have any problem about installation, pls feel free to contact me.

Package: 
10pcs Strip to Wire Connectors (AC-SE-N8XB-2)