Product Review
Specification:
Operating voltage: 2.3-3.3V
Battery type: 2 x AAA LRO3 batteries
Thread size: 1inch NPT
Measure accuracy: ±1%
Maximum working pressure: 20BAR
Flow range: 15-120L / Min
Single count: 0.00-9999.9
Total cumulative count: 0-99999
Working temperature: -10°C ~ +60°C(14°F~140°F)
Standby time: 1 year
Weight: 371g
Problem solving service
*When it appears - normal flow rate but the meter does not count, when the DISPLAY button is pressed, the meter is turned on. In this case, the possible cause is: 1. the impeller is stuck or damaged; 2. the sealant material is wrapped around the impeller; Solution: Remove the meter and ensure that the impeller rotates freely.
*When it occurs - the flow rate is reduced and the meter does not count when the DISPLAY button is pressed, the meter is turned on. In this case, the reasons may be caused by: 1. The meter is partially blocked by the dried liquid; 2. Below the minimum flow rate; Corresponding solution: remove the instrument to ensure that the impeller rotates freely; 2. Increase the flow rate
* When the meter is not working properly, it may be due to a board failure or a button failure. The corresponding solution: replace the circuit board
- Brief introduction - The digital turbine flowmeter has a modular design, high precision, small size and stable performance. The modular design makes it suitable for use with output modules, sensors and remote transmitters. Easy to replace and maintain internal components.
- Feature - Compact structure, convenient installation, intuitive and clear readings, high reliability, measurement accuracy of ±1%, high-definition display shows instantaneous and cumulative flow. Can be widely used to measure diesel, kerosene, gasoline, petroleum, medicine, transportation and commerce.
- When it appears - normal flow rate but the meter does not count, when the DISPLAY button is pressed, the meter is turned on. In this case, the possible cause is: 1. the impeller is stuck or damaged; 2. the sealant material is wrapped around the impeller; Solution: Remove the meter and ensure that the impeller rotates freely.
- When it occurs - the flow rate is reduced and the meter does not count when the DISPLAY button is pressed, the meter is turned on. In this case, the reasons may be caused by: 1. The meter is partially blocked by the dried liquid; 2. Below the minimum flow rate; Corresponding solution: remove the instrument to ensure that the impeller rotates freely; 2. Increase the flow rate.
- When the meter is not working properly, it may be due to a board failure or a button failure. The corresponding solution: replace the circuit board.
