Product Review

If you have any question, feel free to reach out to us:

FB: www.facebook.com/joeblackttt
Email: [email protected]

Our 3d touch is on car leveling sensor for 3D Printers that can precisely measure the tilt of your print surface. It can greatly improve the printing precision of your 3D printer, and it is compatible with most Prusa I3 3D printers.

Note: 3D touch car leveling sensor is not plug_and_play; You may need some work on the connector. We have prepared the pins for you.

Specifications:
Voltage: 5V
Current: 15mA
Max. Current: 300mA
Cable length: 150mm
Net Weight: 10g
Shipping weight: 25g

Condition:
3DTouch can be operated in the following condition.
One I / O for control (PWM or Software PWM)
One I / O for Zmin (Z Probe)
GND and + 5V power

Wiring:
3-pin: Brown (-, GND), Red (+ 5V), Orange (control signal)
2-pin: Black (-, GND), White (Z min)

Caution:
Additional power supply will be needed in case your board does not supply enough amperage.
Electronic devices can be damaged or even destroyed if connected to wrong polarity. [wrong terminal connect to 5V (+) and GND (-)]
Pulling / pushing hard on the push pin damage 3DTouch and make it less accurate.
Fix push-pin with locking paint after reassembling or adjusting core.
Do not remove or deform the elastic material attached to the push pin.

Pack list:
1 X 3D Touch Car Leveling Sensor
1 X 3 Pin Straight Pin
1 X 2 Pin Straight Pin 2 X Screw & Nut & Washer
2 X Dupont Housing Shell 3 Pin
2 X Dupont Housing Shell 2 Pin
3 X Dupont Housing Shell 1 Pin
14 X Dupont Terminal
1 X 10K 1 / 8W resistor


If you have any question, feel free to reach out to us:

FB: www.facebook.com/joeblackttt
Email: [email protected]