Product Review

Dear customer please read the following instructions in detail:
What will you get:
1.100pcs tile Leveler +2pcs special spanner
2 200pcs cross spacer (1.5mm)(1/16in)+ 200pcs cross spacer (2.0mm)(5/64in）
How to use?
1 lay the first piece of brick,seam ≥1.5mm or above, and close to second bricks
2 Insert the T-pin along the crack, then rotate it 90 degrees, clamp the T-pin at the bottom of the two bricks and tighten the adjusting cover so that the two bricks are in the same level
3 Before the cement or tile glue has completely dried up (usually no more than 3-4hours), tighten the adjusting cover in the opposite direction, then rotate the T-pin 90 degrees so that the T-pin turns to a zigzag parallel to the tile, and remove the leveler;
4 Clean and dry storage for reuse.
Make the following three steps in advance to avoid being unable to take out the t-type leveler for reuse:
1.Tile slitting 1.5mm or above, preferably use with cross card;
2.Clean up the cement and debris around the T-needle before installation;
3 After construction, the product must be removed before the cement/binder is completely solidified (please read the instructions of the layer material used carefully).
Tip:
1 When the T-needle is stuck in the bottom of the two tiles, shake it slightly from side to side to make some room for easier removal and reuse.
2 When laying the tiles with length more than 80CM (31.5 inches), the distance between two T-needles shall be kept less than 60CM (23 inches), or add one more T-needle in this side.
Specification:
Material:POM(polyacetal pom) + 430 Stainless Steel
Quantity:100 Sets/Bag + 2Pcs Tool
Suitable Space:1.5mm(1/16in)-3.5mm(9/64in) Space
Tile thickness:3mm(1/8in)-15 mm(19/32in)
Color: As showed in the picture
Please note: this product is not suitable for use when the cement layer or the rubber layer is less than 3mm(1/8in) in brick laying construction.