Product Review

INSTRUCTIONS
1.Switch off the circuit breaker for the intended installation area.
2.Remove any existing switch-plate.
3.Verify there is no power to the switch to be replaced.
4.Remove existing switch.
5.Identify and disconnect power wires from switch.
6.Use the wiring diagram below to connect the dimmer between a 0-10V power supply and 0-10V LED light fixture.
7.Carefully replace wiring back into wall box, mount the dimmer with supplied screws.
8.Install switch-plate.
9.Switch power back on at circuit breaker.

INSTALLATION TIPS
1.Install in accordance with all national and local electrical codes.
2.The maximum load of this dimmer is 1400Watts. There is no minimum load.
3.Use copper power wires that are rated for least 75℃/167℉
4.120Volts Input; 0-10 Volts Output Only.

SAFETY INFORMATION
1.CUT OFF ALL THE POWER CIRCUIT before start installation.
2.120V AC INPUT ONLY. This product requires 0-10V power supply.(Our Allsmartlife 2x2/ 2x4 LED panel light come with a dimmable LED driver so you can follow the instructions to connect.)
3.Shorting output wires may cause damage to dimmer.
4.Always observe proper polarity when connecting power and load.
5.For indoor use only - this product is not waterproof or weatherproof.