Pokémon Sword and Pokémon Shield Double Pack

Product Review

4PCs of brand-new analog joystick for Nintendo Switch Pro wireless controller. The replacement repair parts was made by ALPS which is the same maker as the one in the official controller. OEM quality to ensure games accuracy and prolong lifespan

It's a hard time to take off the problem sensor module with as many as 14 prongs. We figured out ways to make it possible based on situations below:

â— A heat gun to replace the whole assembly
This is the most suggested for an experienced soldering expert
â— Partially replace the 3Pin potentiometer sensor alone with an iron
According to some estimates, 80% chances of problem are caused by the motion sensor. In another words, the joystick rocker and the tactile switch are good. In this case, you can try to swap the 3Pin sensor alone. (We're listing the 3Pin sensors alone.)
â— Replace the white disc alone even without soldering
In some cases, you can just replace the little wheel in the 3Pin potentiometer sensor to solve some specific problems like: Dead spot, blind spot, dead zone, creeping, not as responsive as it should be
â— Experts with a normal iron to replace the whole unit
For a soldering expert with NO professional desoldering wick braid, solder sucker pump or hot air rework station at hand. We suggest to crush the problem thumstick into small enough pieces with a pair of pliers. It will be much more easier than de-soldering the entire 14Pin unit
â— by professional technicians in a cellphone repair shop
Suggested for someone with no handy tools

Scan the barcode included in the package to view the instruction and demonstration offered by ElecGear webpage. We are talking about the stick problems and always trying hard to find a way to make it easier

What's in Package:
4* Analog joystick (For official NS Pro controller ONLY! )
1* PH000 screwdriver

[EL3 for Switch Pro Controller] – 4x replacement analog joystick work with Nintendo Switch Pro and some PS3 controllers. The thumbstick module was made by ALPS. This RKJXV stick controller series comes with 10KΩ trimmer potentiometers
[Compatibility] – This version of analog stick comes in dark gray bottom plate with two plastic sticks inserting in the PCB. It locks in 3 directions when not sit in controller cover. The trim pot resistors can be in green or black. It is widely used in Switch Pro controller. Some reported it is also used in 8Bitdo SNES controllers
[4x Additional Drift Fix PCB] – Several factors cause joystick drifting a common issue. Even new joysticks can drift. The potentiometer was born without precision. Wear to the carbon film, spring fatigue and material stretching made it not centered. Dust, moisture and drop make it worse. We packed 4x PCB to fix the problem of drifting in one direction. Simply adjust the variable resistor to eliminate the drifting
[When to replace] – The analog joystick needs to be replaced when your controller has the problem of drifting, creeping, stuttering, a blind spot, a dead spot, a dead zone, no reaction when clicking, or it wouldn't center after years of wear and tear. The OEM genuine repair parts ensure accuracy and prolong lifespan
[Reminder of DIY] – With as many as 14 prongs, de-soldering and soldering the whole module takes serious skills. We suggest replacing the potentiometers first to solve most of the joystick problems. If you plan to take off the entire joystick module off PCB, we suggest two methods: 1.Take a look at the desoldering kit at product ID: B0BK7169M8. 2.or you can cut the 14 prongs one by one with a wire cutter

Track Price :: Reviewing Millions of Products!

ElecGear 4X Replacement Joystick (EL3 ALPS) + 4X Drift Fix PCB Compatible with Nintendo Switch Pro and PS3 Wireless Controller, Analog Stick Controller Sensor Assembly Thumbstick Module

Product Review