Product Review

Easy To Install and Use Install takes less than 3 minutes. Open controller, plug flex in. Installing your Remap Buttons Takes a little Bit longer. No need to scrape your PS4 4 board, No need to worry about which revision of DS 4 controller you have. This Board is super easy to use. Works with every DS 4 Controller Lets you remap X O TRI SQU (DPAD - UP DOWN LEFT or RIGHT) Also Allows you to remap R1/L1 or R2/L2 Video install instructions available after purchase.. Custom DS4 HARD REMAP Controller FLEX BOARDS. Made for Pro Gamers and master Craftsmen who are also Gamer. Tested by Pro Gamers. Precisely Calibrated for Tournament Action. 100% compatible with ALL GAMES!!!! Especially COD Ghosts, Advanced Warfare and more. Remaps are for gamers who do not want to take their hand off the analogs while playing and what buttons for their grip fingers/hands to press. DISCLAIMER: Please make sure you use a LOW wattage, Low Temp Soldering Iron meant for small PCB electronics. A narrow tip is recommended (1/64th or 1/32nd size tip) Also make sure to use Low temperature melting solder. If you use an iron TOO HOT or TOO Powerful an Iron you can melt the Plastic Flex and ruin the board. If you ruin the board we will not replace or refund you, you take full responsibility for the board once your Soldering iron touches it. Install board between motherboard and Daughter-board and screw motherboard back in tight. Flip board over to motherboard. Solder one Wire to G and one wire to the button you want to remap. Both those wires then go to your tact button. Same install for all buttons except R1 and L1 FOR R1 and L1 remaps - solder a wire to each point of R1 or L1 and then to your tact button. Very Easy, Install. There is an install video Guide on youtube. Go to youtube and add /watch?v=W1TwxXyu_xU