Product Review

First Make sure you have the right controller. Look on the back of your controller. if you have a ZTC1U controller then this will not work you need a controller that has 2U in the model number. Takes less than 10 minutes. Open controller, Install Flex. Installing your Remap Buttons Takes a Bit longer. No need to worry about which revision of DS4 controller you have. This Board is super easy to use. Works with every DS 4 Controller. Lets you remap any of 15 buttons, X O TRI SQU (DPAD - UP DOWN LEFT or RIGHT) R2, L2, L1, R1, R3, L3, Touchpad Click. Photo and Video install instructions available after purchase. Precisely Calibrated for Tournament Action. MLG Approved. 100% compatible with ALL GAMES! Especially Black ops 3 and more. DISCLAIMER: Please make sure you use a LOW wattage, Low Temp Soldering Iron meant for small PCB electronics. A narrow tip is recommended (1/64th or 1/32nd size tip) Also make sure to use Low temperature melting solder. If you use an iron TOO HOT or TOO Powerful an Iron you can melt the Plastic Flex and ruin the board. If you ruin the board we will not replace or refund you, you take full responsibility for the board once your Soldering iron touches it. Install board between motherboard and Daughter-board and screw motherboard back in tight. Solder one Wire to M1 Point 1 and one and a wire from M1 Point 2, both to your tact. Repeat for M2. Both those wires then go to your tact button. Solder a wire from L3 and R3 on the board to the L3 and R3 points on the MOBO. There is an install video Guide on youtube. MODCENTRALUSA