Product Review
How to use this paintless dent repair kits?
1.Clean the dent with a clean wet cloth;2.Mount the glue stick into the glue gun,pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes;
3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is);
4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue);
5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 5 minutes. The cooling time should be less than 8 minutes and should be shorter slightly in winter);
6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent;
7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen;
8. Clean the repaired place with a clean wet cloth.
Package:
12Pcs black rods
6pcs yellow tap down tools
1pcs rubber hammer
1pcs air wedge pump
2PC Chain
1 pcs tool bag
10pcs glue sticks
1pcs glue gun
1pcs dent lifter
1pcs slide hammer
17pcs tabs
1pcs Instructions
Notes:
1.DO NOT let the glue harden completely. It will just break off when you pull the dent. As you pull the dent you should see the glue stretch slightly, and there will be a distinctive metal popping sound if you do it properly.
2.The timing for the glue set will also depend on temperature and humidity.Cool weather may take even less than 1mins.







